Pfeiffer Vacuum HENA 201 R, Руководство по эксплуатации

Страница: 44 / 64

1
2
3
4
Fig. 20: Dismantling / assembling the intake strainer
1 Cylinder screw 3 Vacuum connection
2 Washer 4 Intake strainer
Dismantling the intake strainer
1. Dismantle the intake line.
2. Dismantle the operating fluid return line from the vacuum connection.
3. Unscrew the cheesehead screws.
– Pay attention to the washers.
4. Remove the vacuum connection.
5. Remove the intake strainer from the intake duct.
6. Dismantle the part of the non-return valve resting in the intake duct.
Clean all parts and examine for wear
1. Clean all parts.
2. Examine all parts for wear.
Mounting the intake strainer
1. Mount the parts of the non-return valve.
2. Insert the intake strainer into the intake duct.
3. Fit the vacuum connection.
4. Screw on the cylinder screws.
– Pay attention to the washers.
– Tightening torque:
20 Nm
5. Mount the operating fluid return line to the vacuum connection.
7.6 Changing the gas ballast filter
The gas ballast filter is soiled if the vacuum pump takes in ambient air containing dust during gas ballast
operation. As the soiling increases, the throughput of the gas ballast filter decreases. The risk of con-
densation and corrosion in the vacuum pump increases.
Required consumable materials
● Compressed air
● Gas ballast filter
Maintenance
44/62