Pfannenberg Quadro-LED HI, Инструкция по эксплуатации и установке

Страница: 4 / 12

085 501 993a 4 30084-004-13a
4. Taking into operation
Before commissioning the information provided on the rating plate and in these instructions is to be observed. Non- obser-
vance can lead to the destruction of the beacon and to the jeopardising of safety.
The light is designed to be connected to permanent connection cables. The cable screw connections are suitable for cables
and lines installed in a stationary arrangement.
After connecting it to the power supply and
fi xing/tightening the hood in place, the multifunction light is ready for operation. A
subsequent test is made to ensure satisfactory functional integrity.
Caution: In order to avoid damage to eyesight, please refrain from looking at the light for any length of time when it is in op-
eration.
Wire connection
S1
Operation mode
1 2 3
OFF OFF OFF 1 Flashing light 0,75 Hz
OFF OFF
ON
2 Flashing light 1 Hz
OFF
ON
OFF 3 Continuous light
OFF ON ON 4 Blinking light 1 Hz
ON OFF OFF 5 Flashing light 2 Hz
ON
OFF
ON
6 Blinking light 2 Hz
ON ON
OFF 7 Flashing light 0,1 Hz
ON ON ON 8 Flashing light 0,5 Hz
4. Maintenance, Service and Ordering Spare Parts
The multifunction light is maintenance-free.
The polycarbonate housing may only be cleaned with water and a mild detergent solution.
As a principle, repairs are to be carried out at the manufacturer’s factory. Parts (only use original spare parts) can be replaced
by suitably quali
fi ed personnel.
Control of light intensity
X1
Connection terminal
1 2 3 4
L
N
+ -
S1
Selection of operation mode
2 1
ON
3
Reverse voltage protection!
Function is granted when polarity is reversed.