Design Loading and Editing
What embroidery files does my
creative stylist
™
MN 110 embroidery machine read?
The
creative stylist
™
MN 110 embroidery machine reads .VP3 and .DST embroidery files.
Any special consideration for formatting embroidery files?
The
creative stylist
™
MN 110 embroidery machine will load designs with the center point aligned in
the center of the hoop. In order for a design to load properly centered, ensure that it has been saved
(exported) with a center alignment. Otherwise the design will need to be manually adjusted in the hoop
area.
I want to stitch an appliqué. How do I make the
creative stylist
™
MN 110 embroidery machine
recognize the thread stops?
You can stitch appliqué files but they must be exported and loaded as a .DST file. The .DST format will
show each appliqué step as a separate color. Select the needle color you wish to use for each step, and
also add the frame forward feature to the selected needle colors. This will cause the machine to stop and
move the frame forward automatically after stitching the color designated for placing appliqué fabric,
trimming, etc.
Why won’t my design load?
Make sure that the embroidery status is set to unlocked. The
creative stylist
™
MN 110 embroidery
machine will display a message about changing the embroidery status when exiting stitch out mode.
The
creative stylist
™
MN 110 embroidery machine is set to unlocked status, but I can’t load my
design from my USB drive. Why?
You need to first transfer your design to the machine. Select the file from the list shown for your USB
drive, then touch the Transfer (send to machine) button. This will save the design to machine memory,
where it will be located at the bottom of the design page(s). Select the design from the machine memory
files to load it into the
creative stylist
™
MN 110 embroidery machine.
What is an X or Y limit error?
You will receive one of these errors if your design is too large for the hoop that you have set or if your
design is outside of the preset margin for the hoop. When this happen the outline of the hoop on screen
will be red. To fix this error, you should select a larger hoop and/or move the design so that it is within
the hoop boundaries. The outline of the hoop on screen will change back to black when the design is
completely in the stitchable area of the hoop.
Frequently Asked Questions
®