15
IMPORTANT FOR STORAGE TEMPERATURE FOR WINE
Your wine cooler is designed to provide optimal conditions for storing and/or serving your wines. Good wines
require long and stable development and need special conditions to reach their full potential.
All wines mature optimally at the same ideal temperature, which is a constant temperature between 12ºC and
14ºC. In other words, as long as the temperature of your wine cooler is constant (12ºC - 14ºC), your wines will
be stored in perfect conditions.
Not all wines will improve over the years. Some should be enjoyed young (2 to 3 years), while others have
enormous storage potential (50 years and longer). All wines have a optimal stage of maturity. Talk to your wine
merchant for the best guide.
DEFROSTING/CONDENSATION/ HYGROMETRY/ VENTILATION
This wine cooler is designed with an "Auto-cycle" defrosting system. During "Off-cycle", the cooling surfaces of
the wine cooler are automatically defrosted.
Defrosting/condensation from the storage compartment runs automatically and part of it goes into a drainage
container located at the back of the wine cooler next to the compressor. The heat is transferred from the
compressor and evaporates any condensation collected in the container.
The wine cooler is equipped with a double glass door that has a third inner acrylic layer to minimize condensation
on the glass door. The wine cooler is not completely sealed; fresh air access is done through the drain pipe. Air is
circulated through the cabinet using a fan and the slats of the shelves.
Note:
During the cooling cycle, heat is emitted through the outer surfaces of the wine cooler. Avoid touching the surfaces during these
cycles.
ADJUSTABLE WOODEN SHELVES
For easy access to the stored content, pull the shelves approximately 1/3 of its depth out of the rail
compartment. These wine cabinets, however, are designed with a notch on each side of the shelf tracks to
prevent bottles from falling.
When removing any of these shelves out of the rail compartment, tilt the shelf as per the diagram and simply
pull out, or push in the shelf until it sits on the support brackets securely.
Shelf installation and removal:
Shelf taking: According to below instruction drawing to pull out the shelf to support bracket
①
, press two sides
of sliding roller buckles and pull out the shelf following the arrow mark
②
.
Shelf installation: According to below instruction drawing to push in the shelf alignment with two sides of sliding
roller following the arrow mark
③
.
