After your journey
Step 1
Stopping and correctly closing the car
Press the
START/STOP
button.
Check the following before getting out of the car.
• the gear stick must be in the
“P” position
(press the
P-button.
• The
“READY”
light must be off.
Step 2
Correctly connecting the charging cable
Check if the gear stick is in the “P” position and if the
ignition of the vehicle is turned off before charging. If
not, charging won’t be possible.
• Take the charging cable from the boot of the vehicle
and connect it to the charging station.
• Register at the charging station with the carging pass
(in the driver’s side door).
Press the charging port cover to open it and put the
charging cable in place. The vehicle is charging
correctly if the charging light blinks green in the
charging port. You will also see the remaining time on
the dashboard.
1.
2.
3.
If this isn’t the case, the charging hasn’t started correctly.
Follow the procedure again and check if the charging cable is
plugged in correctly. A red light in the charging port indicates
that the charging cable is locked in place.
Put the charging pass back in the driver’s side door and close the vehicle (after
putting the key back in the onboard terminal) using your cambio- or MOBIB-card
or cambioApp
Always check if the car is charging before leaving!
The light in the charging port or
on the dashboard (time until charging is complete) will indicate if the vehicle is charging.
If the driver's door is opened
while the required conditions
for stopping are not met, an
audible signal is emitted.
Green
=
available
Blue
= charging
Red
=
error
LED lights on terminal
1.
Place the key in the central console or hold it to the left of the
steering column when the car doesn’t detect the key.
2.
Place your right foot on the brake pedal for the following
actions:
- Press the
“START/STOP”
button briefly.
- Keep your foot on the brake pedal until the full
dashboard and all gauges light up.
- Press the
“UNLOCK”
button (B) and select the
“D/B”
(forward) or
“R”
(reserve)
position
– (see indication light at
C).
3.
The
electronic parking break
will release automatically when
you give gas. You can also release it manually by pressing the
(P) button
4
Release the brake pedal gradually and slowly press the
accelerator pedal.
Step 3
Start the vehicle
2
