18
US Customer Care Center 1-800-732-2677
www.petsafe.net
19
To Pair the Remote Transmitter and Receiver Collar
If your Receiver Collar does not beep when the Tone Only Button
of the Remote Transmitter is pressed, or if you feel the Receiver
Collar is not responding to the Remote Transmitter, follow these
steps to pair:
1. With the Receiver Collar off your pet, turn the Receiver Collar on.
2. Turn the Intensity Level Dial on the Remote Transmitter to “
1”.
3. Separate the Remote Transmitter and the Receiver Collar by 2 feet.
4. Press both the top and bottom buttons on the Remote
Transmitter at the same time and hold for ten seconds.
5. The Receiver Collar should emit two beeps.
6. If the Receiver Collar does not beep twice, please contact the
Customer Care Center.
1
2
3 4
5
6
7
8
9
0
1
Test Light Instructions
A-67
1. Turn the Receiver Collar off.
2. Loosen the Contact Points with pliers.
3. Bend the leads around the base of Contact Point.
4. Hand tighten the Contact Points, making sure that the leads stay
in contact with the base of each Contact Point.
5. Turn the Receiver Collar on.
6. Press the Stimulation Only Button on the Remote Transmitter.
7. The Test Light will flash.
Note: At higher Intensity Levels, the Test
Light will flash brighter.
8. Remove the Test Light and tighten the Contact Points with pliers
one-half turn beyond finger tight.
9. Save the test light for future testing.
Note: If the Test Light does not flash, install new batteries and re-test. If Test Light still does not
flash, contact the Customer Care Center or visit our website at www.petsafe.net.
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modification of the terms,
conditions and notices contained herein. Usage of this product implies acceptance of all such
terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific temperament of
your pet may not work with this product. We recommend that you not use this product if your pet
is less than 8 lb or under 6 months old, or if your pet is aggressive. If you are unsure whether this is
appropriate for your pet, please consult your veterinarian, certified trainer or contact our Customer
Care Center or visit our website at www.petsafe.net.
Proper use includes reviewing the entire Operating and Training Guide provided with your
product and any specific Caution statements.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm,
injure, or provoke. Using this product in a way that is not intended could result in violation of
Federal, State or local laws.
4. Limitation of Liability
In no event shall Radio Systems
®
Corporation be liable for any direct, indirect, punitive, incidental,
special or consequential damages, or any damages whatsoever arising out of or connected with the
use or misuse of this Product. Buyer assumes all risks and liability from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices under
which this Product is offered.
FCC
USA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
CAUTION: Modification or changes to this equipment not expressly approved by Radio
Systems
®
Corporation may void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a specific installation. If interference does occur to
radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult customer care, the dealer, or an experienced radio/TV technician for help.
