Petsafe PDT00-14016, Руководство по эксплуатации и обучению

Страница: 6 / 22

6 Customer Care Center 1-800-732-2677
Operating Guide
Step 1
Prepare the Handheld Remote
1. Using a small flathead screwdriver (or equivalent), place into the slot on the bottom and
turn until the top and bottom release ( 1A ).
2. Install one (1), 3-volt (CR2032) battery under the clip, positive (+) side up ( 1B ).
3. Firmly press the top and bottom back together ( 1C ).
Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact the
Customer Care Center or visit our website at www.petsafe.net for a list of common retailers.
Risk of explosion if batteries are replaced by an incorrect type. Do not
short circuit, mix old and new batteries, dispose of in fire, or expose to
water. When batteries are stored or disposed, they must be protected
from shorting. Dispose of used batteries properly.
Step 2
Prepare the Treat Dispenser
1. Remove the battery compartment door ( 2A ).
2. Install four (4) AA batteries into the battery
compartment on the back of the Treat Dispenser ( 2B ).
3. Replace the battery compartment door.
Risk of explosion if batteries are
replaced by an incorrect type. Do
not short circuit, mix old and new
batteries, dispose of in fire, or
expose to water. When batteries
are stored or disposed, they
must be protected from shorting.
Dispose of used batteries properly.
1C 1A 1B
2A 2B