14
Customer Care 1 (800) 732-2677
To assure a proper fit, please follow these steps:
1. Using the edge of the test light tool, turn the battery door to the “off” (
O
) position.
2. Start with your pet standing comfortably (4A).
3. Place the receiver collar on your pet so that the PetSafe
®
logo is facing your pet’s chin. Center the contact points
underneath your pet’s neck, touching the skin. If your pet has a long or thick coat then it may be necessary to
trim the hair around the contact points to make sure that contact is consistent.
4. Adjust the tightness of the receiver collar to fit your pet’s neck. Check the tightness of the receiver collar by inserting
one finger between the end of a contact point and your pet’s neck. The fit should be snug
but not constricting (4B).
5. Allow your pet to wear the receiver collar for several minutes, then recheck the fit. As your pet becomes more
comfortable with the receiver collar, check the fit again.
6. Once you are satisfied with the fit of the receiver collar, you may trim any excess collar strap as follows (4C):
a. Mark the desired length of the receiver collar with a pen. Allow for growth if your pet is young or grows
a thick winter coat.
b. Remove the receiver collar from your pet and cut off the excess.
c. Before placing the receiver collar back onto your pet, seal the edge of the cut collar strap by applying a flame
along the frayed edge.
4A
4C
4B
