Petsafe IN-GROUND FENCE PIG00-10773, Руководство по эксплуатации и обучению

Страница: 31 / 36

www.petsafe.net 31
System Test
The system test is used to determine the cause of system problems that have not been
addressed elsewhere in this guide. You will need a 10 foot piece of Boundary Wire with
3
⁄
8
inch of insulation removed from each end to use as a test loop wire. Follow the steps
below to perform the system test:
1. Remove the Receiver Collar from your dog and make sure it is turned on with a good
battery installed.
2. Unplug the Power Adapter from the Fence Transmitter Power Jack.
3. Set the Boundary Control switch to B.
4. Set the Receiver Collar Static Correction Level to 5.
5. Disconnect the twisted Boundary Wire from the Boundary Wire terminals on the
Fence Transmitter by pressing the red release levers on the connector and pulling the
wires free.
6. Insert the two ends of the test loop wire into the Boundary Wire Terminals on
the transmitter.
7. Plug the Power Adapter into Fence Transmitter Power Jack.
8. Note the original position of the Boundary Width Control knob and turn the
Boundary Width control knob to 10 and then back to 5.
9. Place the Test Light Tool Contacts on the Contact Points of the Receiver Collar. While
holding the Receiver Collar with the Test Light Tool in place, start outside of the test
loop and walk toward the loop. Make a mental note of the distance between you and
the wire when the Receiver Collar activates.
10. Turn the Boundary Width Control knob to 10 and repeat Step 9. The distance where
the Receiver Collar activates should be greater than that of Step 9.
11. If more than one Receiver Collar is used on the system, repeat the above test on
each collar.
12. Interpreting the Results:
a. If the Power light or the Loop indicator light are not both lit on the Fence
transmitter, or the alarm is on, there is a problem with the transmitter.
Contact the Customer Care Center. (Australia and New Zealand only:
Check and replace the Fence Transmitter fuse if necessary. If replacing the
fuse does not correct the problem, there is a problem with the transmitter.
Contact the Customer Care Center.)
b. If both the Power and Loop indicator lights are on, but the Receiver Collar
does not activate on the test loop wire, the Receiver Collar is not working.
Contact the Customer Care Center.
c. If both the Power and Loop indicator lights are on and the Receiver Collar is
activating at different distances on the test loop wire, the problem is either
in the containment Boundary Wire or the Surge Protector. (USA and Canada
Only: Reconnect the transmitter wires to the Surge Protector and connect
the test loop to the Surge Protector Loop terminals. Repeat steps 7 through
10.)
13. If both the Power and Loop indicator lights are on and the Receiver Collar is
activating at different distances on the test loop wire, the problem is in the
containment Boundary Wire. Perform the Wire Break Location Test. (USA and Canada
Only: If the Loop indicator light is off with an alarm on the Fence Transmitter, there is
a problem with the Surge Protector. Contact the Customer Care Center.)
14. When testing is complete, return the Boundary Control Switch and the Boundary
Width Control setting to their original position.
15. Repeat the Boundary Width testing from Step 6 on Page 18 until you achieve the
desired Boundary Width between 12 to 20 feet.