www.petsafe.net 7
Operating Guide
Set Up the Transmitter
Important: You may need to move the Transmitter several times before determining the final location.
The Transmitter is located at the exact center of the Pet Area. Place the Transmitter:
• At least 2 feet above the floor located on the ground floor of your home.
• In a dry, well ventilated, protected area.
• In an area where temperatures do not fall below freezing (e.g., garage, shed, closet).
• On a non-metal table or mount on a wall (
1A
). A mounting template is included on the back of
this guide.
• At least 3 feet from large metal objects, as these items may reduce the size and shape of your
Pet Area (
1B
).
To maximize your Pet Area, make
sure the Boundary Switch is on
“High” and the Boundary Control
Dial is set to “8” (
1C
). Plug Power
Adapter into Power Jack and
standard 120-volt outlet. Turn the
Transmitter on.
Wall
Mount
Tabletop
1A
3ft.
1B
BOUNDAR
Y
CONTROL
7
8
Power
Boundary
Switch
Low
High
8
1C
Prepare the Receiver Collar
Your Receiver Collar comes with short Contact Points installed. Use the Long
Contact Points for pets with long or thick hair. Tighten the Contact Points using
the Test Light Tool (
2A
) one-half turn beyond finger tight. Check the tightness
weekly.
To Insert and Remove the Receiver Collar Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe
®
battery (RFA-67). This
unique battery is designed to make battery replacement easier and increase
water protection.
To insert the battery, align the symbols on the battery (arrow) and Receiver
Collar (triangle) (
2B
). Use the edge of the Test Light Tool (
2B
) to turn the
battery clockwise until the arrow lines up with the lock symbol on the housing.
To remove or replace the battery, turn the battery counter-clockwise using
the edge of the Test Light Tool (
2C
). DO NOT attempt to cut into or pry open
the battery. Be sure to discard the used battery properly. When removing
the old battery from the Receiver Collar, discharge all power by holding the
correction level button down until the light is no longer illuminated. Replace
with a new battery.
A replacement PetSafe
®
battery (RFA-67) can be found at many retailers.
Contact the Customer Care Center at 1-800-732-2677 or visit our web site at
www.petsafe.net to locate a retailer near you.
2A
2B
2C
Step
1
Step
2
