Peterbilt 220, Руководство оператора

Страница: 106 / 136

1. Remove the surge tank pressure cap
(do not remove the surge tank coolant
level sensor cap).
2. Fill system with premixed coolant to
“MAX” level on surge tank and allow
coolant level to settle.
3. Repeat step 2 until coolant level stays
at “MAX” level.
4. Start the engine and idle at low RPM
for 2 minutes.
5. Top off surge tank to “MAX” level while
engine is at low idle.
6. Run engine at high idle until operating
temperature is reached (~ 200° F).
7. Return engine to low idle and top off
surge tank to “MAX” level if needed.
8. Run engine at high idle for 10 minutes.
9. Return engine to low idle and top off
surge tank to “MAX” level.
10. Allow engine to cool and top off surge
tank to “MAX” level if necessary.
11. Replace the surge tank pressure cap.
CAUTION
Failure to follow this procedure and
maintain proper coolant level can
cause engine damage.
It is OK for a hot system to have coolant
above the “MAX” level, but a cold system
should not have coolant above the “MAX”
level.
Windshield Washer
Reservoir Fluid Level
1. Open the front panel.
2. Check the fluid level in the screen
washer reservoir.
3. Top up, if necessary, via the filler
opening.
NOTE
When topping up, it is recommended
to add a windshield cleaner to the wa-
ter in the windshield washer reservoir.
During the winter period, add wind-
shield wash antifreeze.
MAINTENANCE - Windshield Washer Reservoir Fluid Level
104 Y53-6078-1B1 (12/18/18)
5