Peter Lynn LEI series, Руководство пользователя, Страница: 11 / 20

StEP 5 - LaunChinG yOur kitE
90
o
Launching is best done using an
assistant. The assistant should grab
the leading edge of the kite near the
center, and lift the kite up with one
tip on the ground and the leading
edge into the wind, as if the rider
flew the kite to the edge of the wind
window. Grab the bar and attach the safety
leash.
Walk towards the position where your
lines are at 90 degrees to the wind
direction.
Find the right position with slight ten-
sion on your lines, where the fabric of
the kite does not flutter and the kite
can’t fly further towards the edge of
the wind window. Your assistant can now check that the
bridle is not hooked behind itself or
any part of the kite. Check your flying lines to make sure
they are not twisted or tangled. Check
that the flying lines or any parts of the
bar are not hooked behind each other.
Check that you are holding your bar
the right way around. Check that your
power adjuster is set correctly.
When you are ready to launch, signal
to your assistant. Your assistant may
now let go of the kite. Slowly steer
the kite up along the edge of the wind
window.
90
o
90
o
90
o
tiPS fOr LaunChinG yOur kitE
• Make sure you are not launching in an area with obstacles like poles or cars,
make sure the area is free of people or other kiteflyers. Do not fly your kite
near powerlines, airports, highways, or in thunderstorms.
• Make sure your equipment is in good working order. Check for wear and tear
and make sure your bar and safety system are in good working order before
you launch.
• Make sure the ground is free of sharp objects to prevent the fabric from
getting damaged.
• Only launch while hooked into a harness when you have an advanced skill
level and you are confident with the wind conditions.
• When in doubt of the wind strength, try a smaller kite first.
• Check your flying lines properly. Before attempting your launch, make sure
they are free of twists and tangles. Also check if they are not hooked behind
any part of your bar or spreader bar before you launch.