Motor installation
Disassembly / Maintenance
The maximum rated horsepower for our Fishing Boats are:
Read the instruction manual supplied by the outboard motor manufacturer. All outboards are slightly different, and some
require special installation procedures. Below is a general outline:
•
Set the motor on tilt and tilt the mounting bracket.
•
Place the motor in the center of the transom.
•
Screw the mounting brackets securely to the transom.
1. To defl ate the P330-HF, remove the valve cap from the valves in the side tubes.
2. Clean and check the P330-HF as well as all the accessories. Make sure the P330-HF is
completely dry before putting it away. Make sure that no sand nor gravel remains inside theP330-HF:
this could result in abrasion or even punctures while storing the P330-HF.
3. Remove bench seats.
4. Remove side joiners from fl oorboards.
5. Raise the middle panel and detach from “H” joints.
6. Remove fl oor panels, remove bow and transom fl oorboards.
7. Fold the 2 sides into the middle, then roll it up from the opposite end of the valves making sure the two rear cones
are folded towards the transom (so remaining air can escape from the valves).
8. When storing your boat, keep it in a clean and dry place.
9. Roll the boat from either end and place in carry bag along with equipment.
Note: If you install a motor larger than the maximum rated horsepower for your boat, you might have
control problems and risk serious injury. Never exceed the maximum rated horsepower.
Note : If the mounting brackets are not tightly secured to the transom, the motor could loosen in use or
even fall from your boat. Make sure they are tight.
6
P330-HF
• Max HP: 15 / 11 kW
Whenever you take your P330-HF out of the water and defl ate it, allow time for it to air out and dry.
Neither the skin/hull or the inside chambers will suffer from water damage, but stagnant water could
cause mildew and foul odor.
Содержание P330-HF
Страница 1: ...Fishing Boats Owner s manual EN...
