page 2.6
10/96
P/N 81905903860
INSTALLATION
2
Section 2
Installation
RCP-GPIO
2.7 Terminating Control Cable Runs
Each cable run should be terminated with a 120 ohm, 1/4 watt 5% resis-
tor. The cable is terminated internally at the controller. See Figure 2-5.
1. Un-crimp the black and red leads in positions one and three.
2. Insert the resistor leads into positions one and three along with the
black and red leads.
3. Crimp down using a screwdriver.
4. The shield wire remains in position two.
Figure 2-5 Terminating Control Cable Runs
