3
2.
Follow Instructions
All installation, operation and other
instructions should be followed.
3.
Warnings
All warnings on the 200P and in the
Owners Manual should be strictly
adhered to.
4.
Water and Moisture
The 200P should not be used near water,
for example near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet
basement, near a swimming pool, etc.
5.
Rack / Wall / Ceiling Mounting
The 200P should be rack mounted only
in a heavy duty rack or stand that is
recommended for audio equipment use.
Mounting to a wall or ceiling should be
via a heavy duty bracket or shelf
designed for audio equipment use.
6.
Heat
The 200P should be situated away from
heat sources such as radiators, stoves,
or other appliances that produce
excessive amounts of heat. Always
ensure the 200P heat sinks have
adequate ventilation enabling air
circulation both above and below. Do not
place the 200P directly onto carpeted
surfaces.
7.
Power Sources
The 200P should be connected to a
mains power supply only of the type
described in the operating instructions, or
as marked on the rear of the 200P.
8.
Power Cord Protection
The mains power supply cord should be
routed so that it is not likely to be walked
on or pinched by items placed on or
against it. Pay particular attention to the
cord at power points, convenience
receptacles, and the point where it exits
from the 200P.
9.
Cleaning
When cleaning ‘P’ series product use
luke warm water with a few drops of a
mild non caustic detergent .
DO NOT USE SOLVENTS.
10.
Non-use Periods
The mains power cord of the 200P
should be unplugged from the mains/line
outlet when the unit is to be left unused
for long periods of time.
11.
Object and Liquid Entry
Care should be taken so that objects
and/or liquids do not accidentally fall
inside the 200P.
12.
Damage Requiring Service
The 200P should be serviced by qualified
service personnel if any of the following
occur :
a. The mains power-supply cord,
and/or plug have been damaged
b. Objects have fallen, or liquid has
been spilt into the 200P
c. The 200P has been exposed to
rain and/or excessive moisture
d. The 200P does not appear to
operate normally, or exhibits a
marked change in performance
e. The 200P has been dropped, or
the chassis damaged.
13.
Servicing
The user should not attempt to service
the 200P beyond those means described
in the owners manual. All other servicing
should be referred to qualified service
personnel.
14.
Grounding or Polarisation
Precautions should be taken so that the
grounding or polarisation of the 200P are
correct, and are maintained through-out
the entire system.
WARNING: THE 200P IS A HIGH
POWERED CONVECTION COOLED
AMPLIFIER. THE FINNED OUTER HEAT
SINKS MAY BECOME VERY HOT WHEN
DELIVERING HIGH VOLUME LEVELS - TO
AVOID INJURY CARE SHOULD BE TAKEN
NOT TO TOUCH THE HEAT SINKS
DURING OPERATION.
IMPORTANT INFORMATION
Always make sure the volume control of your
preamplifier or source unit is set to zero and
the mains/line supply disconnected from your
200P prior to performing any switching
functions or connection alterations of any
type to your system. This caution also applies
