Permobil K450, Руководство по обслуживанию

Страница: 27 / 72

27
Brake release control
Brake release control
Removal
1. Place the wheelchair on a level surface.
2. Switch off the main power switch on the
control panel.
3. Switch the main fuse to OFF. See illustration.
4. Remove the left rear wing. See page 10.
5. Remove the protective plate, which is held in
place with three screws. See illustration.
6. Unplug the brake release switch at the contact
on the cable. See illustration.
7. Remove the magnetic brake and the release
control held in place with three screws. See
illustration below.
8. Remove the brake release cables from the
release control. Both the left and right cable
are held in place in the same cotter and are
secured with the same lock loop. See
illustration below.
9. Loosen the locking nuts and fully unscrew the
adjustment screws.
Fitting
Fit in the reverse order.
Use a torque wrench to tighten the
screws holding the magnetic brake in place to
2.1 ft-lbs (2,9 Nm)
The protective plate is held in place
with three screws.
The left magnetic brake and the release control
are held in place with three screws.
The cables are secured to the cotter
with a lock loop.
Unplug the brake release switch cable
at the contact on the cable.
Check the function of the brake release after fitting. When the
brakes are disconnected, it should not be possible to drive
the wheelchair.

NOTE