15
9.2
HOW TO GET WATER OF A REQUIRED TEMPERATURE
1. After you connect Water Distributor to power supply press
“HOT POWER”
button.
“POWER ON”
light will be
on.
When water is boiled to 100 °C, the light on the control panel will change from
“HEATING” to
“KEEP WARM”
.
Water Distributor fills in the main water tank and keeps it warm even at different intervals, without the necessity
to press
“REBOIL”
button. Thanks to this function a constant access to hot water is assured.
2.
Press
“REBOIL”
to heat water. At this moment the light will change from
“KEEP WARM”
to
„HEATING”
.
3.
In order to cool water first press the cold water button lever and then
“COLD POWER”
button
.
CAUTION:
If it is not necessary, do not press “COLD POWER” button. You can do it again
after 3 minutes (in order to protect the compressor).
Cold water temperature is set within the range 4-12 °C.
You can regulate the temperature by the use of a controller mounted at the back side of Water
Distributor. The higher the value on the scale the lower the temperature.
10. WATER DISPENSER SERVICE AND MAINTENANCE
10.1
WATER DISTRIBUTOR CEANING
1. Make sure Water Distributor is unplugged before you start cleaning.
2. Remove the top cover, cool water tank cover and hot water tank cover.
3. By the use of cold, cool and hot water button levers release the remaining water.
4. In order to empty the cold water tank remove the drain plug from the water tank, which is is located at
the back side of the Water Distributor.
5.
Clean the hot and cool water tanks ONLY by the use of disinfecting substances admitted for food
industry by appropriate authorities.
CAUTION:
do not tilt the water distributor to the sides during cleaning. it may cause severe system
damages by flooding it with water. after you have cleaned or installed the system, wait 10 minutes before
you press “cold water” button.
10.2
PREFILTERS EXCHANGE
CAUTION:
the producer does not take responsibility for installing cartridges, membranes and other
reverse osmosis equipment elements different than those provided in the set. the producer is not liable
for any damages caused to the systems due to improper installation or usage of water treatment
elements.
In order to exchange the prefilters, follow the isntructions given below:
1. Cut off water supply by turning the ball valve located on the water supply to close position.
2. Unplug the Water Distributor.
3. Leave the system for 3-5 minutes in order to lower the pressure to the minimum.
4. Unscrew the prefilters to the left (counterclockwise). Do it carefully, as the cartridges are filled with water.
5. Unpack new cartridges from any protection foil and line up the new cartridge with the center of the head.
6. Install new prefilters on prefilters' head by turning them clockwise. Tighten them firmly.
DO NOT
use any wrenches to
change prefilters.
