Permaquip Sleeper Squarer, Быстрое руководство

Страница: 17 / 61

MAN/M/O/197-03
17
•
With the oil gun provided, push onto the fill screw located on the brake
handle assembly.
•
Slightly undo this fill screw and push the oil gun to allow oil into the
master cylinder. The brake handle will rise until the cylinder is full. Once
full, tighten the fill screw and remove the oil gun.
•
Undo the bleed screw, also located on the brake handle assembly, until
a small amount of oil comes out. This will remove any residual pressure
in the system.
•
Recheck the brakes operate as previously described.
7.2 Weekly Maintenance/Safety Checks
1. Check the condition of the self sealing, quick release couplings. Replace if
damaged.
2. Check the hydraulic hoses and pipes for visible signs of damage. Replace as
required.
3. Check the security of the ram connecting pins. Replace as required.
4. Visually check the condition of the rail clamps for damage to welds and pivot
pins. Replace as required.
5. Visually check the condition of the chain for damage and wear. Replace as
required.
7.3 Annual/every 250 hours of running (which ever occurs first)
1. Drain off the hydraulic oil.
2. Remove the suction strainer and filler from the hydraulic oil tank and clean.
3. Check the return line filter indicator and if necessary replace the filter
element.
4. Clean out any silt from the hydraulic oil tank.
5. Refit the suction and filler strainer. Refill the tank with clean hydraulic oil, as
specified in the Technical Specification.
6. Check the condition of the engine anti-vibration mounts. Replace as required.
7. For a Sleeper Squarer, place the assembly on a flat, level test track. With the
brakes on, connect a load cell to the frame and pull horizontally, aligned with
the track. The brakes should prevent the wheels from turning when the load
cell reads a minimum of 30kg.
8. For a Sleeper Positioner, place the assembly on a flat, level test track. With
the brakes on, connect a load cell to the frame and pull horizontally, aligned