Perlick PKHT24, Руководство по установке и эксплуатации, Страница: 9 / 20

Commercial Glasswasher Installation & Operation Manual
Printed in USA 9
Booster Heater Setup
The booster tank must be fi lled with water before the heating element is energized. For this reason, the
“High Limit Switch” has intentionally been disconnected at the factory and will require re-connection
before the heating element will turn on.
Follow the procedure below to complete the initial installation:
1. Close the door on the machine.
2. Turn the Power switch to the “ON” position.
3. Hold the “FILL” switch in until water overfl ows into the scrap tray.
4. Turn the Power switch to the “OFF” position.
5. Connect the blue wire with the disconnect, identifi ed by a red tag, to the High Limit Switch, which is
located behind the thermostat behind the front kick panel.
Installer Checklist

Glasswasher checked for concealed damage

Hot water supply is 140° F (60 C) — minimum

Incoming water supply line is ½” — minimum

Incoming water supply is 6 GPM minimum at 24 psi

Supply circuit breaker for machine is properly sized (50 amp)

Service voltage and phase type are correct to machine data plate

If drain pump is used, drain hose rises 12 to 16” before dropping to drain

Drain hose is installed with air gap (discharge 1” above drain)

Glasswasher is properly grounded

Glasswasher is properly leveled

Machine circuit breaker is labeled “GLASSWASHER”

Machine has been “hard-wired” with correctly sized wire

Booster tank has been fi lled with water (before High Limit Switch is reset)

High Limit Switch for heater has been reset (after Booster Tank has been fi lled)