4B-1
4B-2
ø10mm
70mm
Position the template at your desired
height, level the template and mark
the pilot hole locations.
Drill 4 pilot holes using a 10mm
diameter drill bit. Make sure the
depth is not less than 70mm Never
drill into the mortar between blocks.
8
4B-3
Use the hammer to
knock anchors [A3]
into the wall.
A1
A2
A3
Install wall plate using lag bolts [A1], washers [A2] and anchors
[A3]. Be sure the anchors [A3] are seated flush with the concrete
surface. Tighten the lag bolts [A1] only until the washers [A2] are
pulled firmly against the wall plate. DO NOT over-tighten the lag
bolts [A1].
07
