IOLAN SDG1 LA/LE Hardware Installation Guide
Installation
General Cautions and Warnings
Warning
:
Power sources must be off prior to beginning the power connection steps.
Read the installation instructions before you connect the unit to its power source.
Warning
:
Ensure that the voltage and current ratings of the intended power source are
appropriate for the IOLAN as indicated on the product label.
Warning
:
Ensure that the installation and electrical wiring of the equipment is performed
by trained and qualified personnel and that the installation complies with all local and
national electrical codes.
Warning
:
The working voltage inputs are designed for operation with Safety extra low
Voltage (SELV). Connect only to SELV circuits with voltage restrictions in line with IEC
62368-1:2018
Warning
: If this equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
Warning
:
Transient protection shall be provided that is set at a level not exceeding 140%
of the peak rated voltage value at the supply terminals to the equipment.
Warning
:
In case of malfunction or damage, no attempts at repair should be made. Do
not dismantle the product. All repairs need to be made by a qualified Perle
representative.
Warning
:
This unit should be installed in a restricted access location where access can
only be gained by service personnel or users who have been instructed about the reasons
for the restrictions applied to the location and about any precautions that shall be taken;
and access is through the use of a tool or lock and key, or any means of security, and is
controlled by the authority responsible for the location.
