Perle IOLAN SCG Series, Руководство по установке оборудования

Страница: 10 / 21

10
IOLAN SCG Hardware Installation Guide
IOLAN SCG Components
4. On the PC, select Choose Start-> Control Panel-> Hardware and Sound or equivalent on the
Windows Operating System you are using. The exact procedure may vary depending on the ver-
sion of Windows you are using.
5. Click the Hardware tab and choose Device Manager, Expand the Ports (COM & LPT) section.
This will expand the drop down to show the number of com ports on your system. Connect the
cable to one of these ports (probably COM1 or COM2).
6. Start a terminal emulation program (such as Putty or SecureCRT) on the COM port where you
have connected the cable to the PC.
7. Configure this COM port within the terminal emulation program with the following parameters:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• None (flow control)
8. Press the Enter key on the keyboard and the login prompt will display.
9. The login is
admin and password is superuser .
See Appendix C - Cabling and Pinouts for cabling information.
See the IOLAN CLI Reference Guide V5.0 and greater for more information on using the CLI
commands.
Micro-USB Console Port
To connect to the Micro-USB Console port:
1. Connect the power, then set the power switch on the back of the IOLAN to the On position.
2. Allow the IOLAN to complete the boot up sequence.
3. Connect a USB cable to the PC’s USB port, then connect the other end of the cable to the IOLAN
Micro-B USB connector.
4. On the PC Choose Start -> Control Panel -> Hardware and Sound (or equivalent) on the Windows
Operating System. Choose the Device Manager, and expand the Ports section. The assigned COM
port can be identified.
5. Start a terminal emulation program (such as Putty or SecureCRT) on the com port where you have
connect the cable to the PC.
6. Configure your COM port within the emulation program on the PC as:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• None (flow control)
7. Press the Enter key on the keyboard and the login prompt will display.
8. The Login is
admin and password is superuser .
See the IOLAN Command Line Interface Reference Guide V5.0 and greater for more information on
using the CLI commands.