Appendix D - DIN Rail and Wall Mounting 29
IDS-509C Hardware Installation Guide
Wall Mounting the IDS
If you have purchased the optional wall mounting kit then proceed as below:
1. Remove the DIN rail clip from the rear panel on the IDS switch.
2. Attach the wall mount plates to the IDS switch as shown below using the screws pro
-
vided in the kit.
3. Use the wall mount plates as a guide to mark the spot where the screws will be placed.
4. Drive the screws into the wall leaving about 2 mm of the screw protruding from the
wall to allow room for sliding the wall mount panel between the wall and the screws.
5. Once the screws are fixed to the wall, insert the four screw heads through the large
parts of the keyhole shaped screw openings
6. Pull the IDS switch down to lock the IDS switch to the wall mount.
7. Tighten the four screws securely to the wall.
Note:
for best results use screws with the following attributes Head diameter .5 - .6 mm
Shaft diameter 3 -3.5 mm
