4.
Install the engine oil filter, spin on the oil filter until
the O ring seal contacts the oil filter base. Then,
rotate the oil filter ¾ of a full turn, by hand only.
Vertically Up Oil Filter
Illustration 60
g02596778
(4) Vertically up oil filter
Some oil filters may be installed vertically up. Use the
same procedure in order to replace the oil filter.
Ensure that all the oil has drained from the filter
before removal.
Fill the Oil Pan
1.
Remove the oil filler cap. Refer to this Operation
and Maintenance Manual, “Fluid
Recommendations” for more information on
suitable oils. Fill the oil pan with the correct
amount of new engine lubricating oil. Refer to this
Operation and Maintenance Manual, “Refill
Capacities” for more information on refill
capacities.
NOTICE
If equipped with an auxiliary oil filter system or a re-
mote filter system, follow the OEM or the filter manu-
factures recommendations. Under filling or over filling
the crankcase with oil can cause engine damage.
2.
Start the engine and run the engine at
“
LOW IDLE
”
for 2 minutes. Perform this procedure in order to
ensure that the lubrication system has oil and that
the oil filters are filled. Inspect the oil filter for oil
leaks.
3.
Stop the engine and allow the oil to drain back to
the oil pan for a minimum of 10 minutes.
Illustration 61
g02829378
Typical example
4.
Remove the engine oil level gauge in order to
check the oil level. Maintain the oil level between
the MIN mark and MAX mark on the engine oil
level gauge. Do not fill the crankcase above the
MAX mark.
i04401341
Fan
Clearance
-
Check
There
are
different
types
of
cooling
systems.
Refer
to
the
OEM
for
information
on
clearance
for
the
fan.
Ensure
that
the
engine
is
stopped.
Ensure
that
the
battery
disconnect
switch
is
in
the
OFF
position.
Ensure
that
the
cooling
system
is
full.
The
clearance
between
the
cover
(1)
and
the
fan
(2)
will
require
checking.
The
gap
(A)
between
the
edge
of
the
cover
and
the
tip
of
the
fan
blade
must
be
checked
in
four
equally
spaced
positions.
SEBU9068-03
103