Perkins 5006A-E23TA, Руководство по эксплуатации и обслуживанию, Страница: 14 / 100

• Use exhaust ventilation on permanent machining
jobs.
• Wear an approved respirator if there is no other
way to control the dust.
• Comply with applicable rules and regulations for
the work place. In the United States, use
Occupational Safety and Health Administration
(OSHA) requirements. These OSHA requirements
can be found in “29 CFR 1910.1001”.
• Obey environmental regulations for the disposal of
asbestos.
• Stay away from areas that might have asbestos
particles in the air.
Dispose of Waste Properly
Illustration 16 g00706404
Improperly disposing of waste can threaten the
environment. Potentially harmful fluids should be
disposed of according to local regulations.
Always use leakproof containers when you drain
fluids. Do not pour waste onto the ground, down a
drain, or into any source of water.
i07390117
Burn Prevention
Coolant
When the engine is at operating temperature, the
engine coolant is hot. The coolant is also under
pressure. The radiator and all lines to the heaters or
to the engine contain hot coolant. Any contact with
hot coolant or with steam can cause severe burns.
Allow cooling system components to cool before the
cooling system is drained.
Check that the coolant level after the engine has
stopped and the engine has been allowed to cool.
Ensure that the filler cap is cool before removing the
filler cap. The filler cap must be cool enough to touch
with a bare hand. Remove the filler cap slowly to
relieve pressure. Refer to this Operation and
Maintenance Manual, Cooling System Coolant Level
- Check for more information.
Cooling system conditioner contains alkali. Alkali can
cause personal injury. Do not allow alkali to contact
the skin, the eyes, or the mouth.
Oils
Skin may be irritated following repeated or prolonged
exposure to mineral and synthetic base oils. Refer to
your suppliers Material Safety Data Sheets for
detailed information. Hot oil and lubricating
components can cause personal injury. Do not allow
hot oil to contact the skin. Appropriate personal
protective equipment should be used.
Viton Seals
If Viton is burned, a product of this burnt material
is an acid which is hazardous. Do not allow burnt
material to come into contact with the skin or with
the eyes. Use the appropriate set of Personal Pro-
tective Equipment to protect your skin and eyes.
Failure to follow the instructions or heed the
warning could result in serious injury or death.
If there is need to come into contact with components
which have been burnt, ensure that the precautions
which follow are used:
• Ensure that the components have cooled.
• Use Neoprene gloves and discard the gloves
safely after use.
• Wash the area with calcium hydroxide solution
and then with clean water.
• Disposal of components and gloves which are
contaminated must be in accordance with local
regulations.
14 M0122761
Safety Section
Burn Prevention