• Avoid brushing materials that contain asbestos.
• Avoid grinding materials that contain asbestos.
• Use a wet method in order to clean up asbestos
materials.
• A vacuum cleaner that is equipped with a high
efficiency particulate air filter (HEPA) can also be
used.
• Use exhaust ventilation on permanent machining
jobs.
• Wear an approved respirator if there is no other
way to control the dust.
• Comply with applicable rules and regulations for
the work place. In the United States, use
Occupational Safety and Health Administration
(OSHA) requirements. These OSHA requirements
can be found in “29 CFR 1910.1001”.
• Obey environmental regulations for the disposal of
asbestos.
• Stay away from areas that might have asbestos
particles in the air.
Dispose of Waste Properly
Illustration 10
g00706404
Improperly disposing of waste can threaten the
environment. Potentially harmful fluids should be
disposed of according to local regulations.
Always use leakproof containers when you drain
fluids. Do not pour waste onto the ground, down a
drain, or into any source of water.
i06276622
Burn
Prevention
Do
not
touch
any
part
of
an
operating
engine
system.
The
engine,
the
exhaust,
and
the
engine
aftertreatment
system
can
reach
temperatures
as
high
as
650°
C
(1202°
F)
under
normal
operating
conditions.
Allow
the
engine
system
to
cool
before
any
maintenance
is
performed.
Relieve
all
pressure
in
the
air
system,
hydraulic
system,
lubrication
system,
fuel
system,
and
the
cooling
system
before
the
related
items
are
disconnected.
Contact with high pressure fuel may cause fluid
penetration and burn hazards. High pressure fuel
spray may cause a fire hazard. Failure to follow
these inspection, maintenance and service in-
structions may cause personal injury or death.
After the engine has stopped, wait for 10 minutes in
order to allow the fuel pressure to be purged from the
high-pressure fuel lines before any service or repair
is performed on the engine fuel lines. The 10 minute
wait will also allow static charge to dissipate from the
low-pressure fuel system.
Allow the pressure to be purged in the air system, in
the hydraulic system, in the lubrication system, or in
the cooling system before any lines, fittings, or
related items are disconnected.
12
SEBU9075-03
