7.
Loosen the connection (5).
8.
Operate the handle (4) until fuel that is free of air
flows from the connection (5).
9.
Tighten the connection (5).
10.
Loosen connections (6) and (8).
11.
Operate the handle (4) until fuel that is free of air
flows from the connection (6) and (8).
12.
Tighten connections (6) and (8).
One cylinder is now primed. An amount of fuel will
have reached the remaining cylinders.
13.
Push the handle and twist the handle in order to
return the priming pump to the locked position.
14.
Operate the starting motor and crank the engine.
After the engine has started, run the engine for a
minimum of five minutes.
Note:
Operating the engine for this period of time will
purge the remaining air from the fuel system.
i08246204
Fuel System Filter - Replace
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Ensure that the engine is stopped before any servic-
ing or repair is performed.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
NOTICE
The water separator can be under suction during nor-
mal engine operation. Ensure that the drain valve is
tightened securely to help prevent air from entering
the fuel system.
Fuel Filter with Water Separator
Table 15
Required Tools
Tool
Part Number
Part Name
Qty
A
-
Strap Wrench
1
Note:
Two fuel filters are installed. Both fuel filters
must be replaced at the same time.
1.
Isolate the fuel supply to the engine.
2.
Place a suitable container under the fuel filter to
catch any fuel that might spill.
Note:
Clean up any spilled fuel immediately.
Illustration 75
g02126034
3.
Loosen the drain plug (2). Allow the fluid to drain
into the container.
4.
Clean the outside of the fuel filter. Use Tooling (A)
to remove the canister (1).
Note:
Dispose of the canister in accordance with
local regulations.
5.
Lubricate the O-ring seal on the new canister with
clean fuel oil. Install the new canister. Tighten the
canister by hand.
6.
Tighten the drain plug (2) to a torque of
1.5 to 2 N·m (13.3 to 17.7 lb in).
7.
Restore the fuel supply to the engine.
76
SEBU8604-02
