Perkins 2806J-E18TTA, Руководство по эксплуатации и обслуживанию, Страница: 58 / 100

NOTICE
Most commercial cooling system cleaning agents are
corrosive and their use is not recommended by
Perkins.
The cooling system must be thoroughly flushed with
clean water after using cleaning agents.
Cleaning agents for marine or industrial cooling sys-
tem must not be used. These cleaning agents are
veryaggressiveand can cause damage to cooling
system components.
• Run the engine for approximately 30 minutes and
then leave the engine to cool down.
• Take a sample of the solution from the cooling
system, drain the system.
• Allow the sample to sit for at least 30 minutes and
check for signs of oil and deposits. If oil and
deposits are still present, repeat the procedure.
• Flush the system with clean water.
• Fill the system with new coolant.
i07835649
Fluid Recommendations
(General Fuel Information)
• Glossary
• ISO International Standards Organization
• ASTM American Society for Testing and
Materials
• HFRR High Frequency Reciprocating Rig
for Lubricity testing of diesel fuels
• FAME Fatty Acid Methyl Esters
• CFR Co-ordinating Fuel Research
• ULSD Ultra Low Sulfur Diesel
• RME Rape Methyl Ester
• SME Soy Methyl Ester
• EPA Environmental Protection Agency of
the United States
• PPM Parts Per Million
• DPF Diesel Particulate Filter
• v/v (volume of solute)/(volume of solution)
• CFPP Cold Filter Plugging Point
• BTL Biomass to liquid
• GTL Gas to liquid
• CTL Coal to liquid
• HVO Hydrotreated Vegetable Oil
General Information
NOTICE
Every attempt is made to provide accurate, up-to-
date information. By use of this document you agree
that Perkins Engines Company Limited is not respon-
sible for errors or omissions.
NOTICE
These recommendations are subject to change with-
out notice. Contact your local Perkins distributor for
the most up-to-date recommendations.
Diesel Fuel Requirements
Perkins is not in a position to continuously evaluate
and monitor all worldwide distillate diesel fuel
specifications that are published by governments and
technological societies.
The “ Perkins Specification for Distillate Diesel Fuel ”
provides a known reliable baseline to judge the
expected performance of distillate diesel fuels that
are derived from conventional sources.
Satisfactory engine performance depends on the use
of a good quality fuel. The use of a good quality fuel
will give the following results: long engine life and
acceptable exhaust emissions levels. The fuel must
meet the minimum requirements that are stated in
the table 13 .
NOTICE
The footnotes are key part of the Perkins "Specifica-
tion for Distillate Diesel Fuel" Table. Read ALL of the
footnotes.
58 M0109073
Maintenance Section
Fluid Recommendations