Perkins 1300 EDi Series, Руководство по ремонту, Страница: 160 / 264

10
148 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
Pressure relief valve
To remove and to fit Operation 10-17
To remove
Note: The pressure relief valve operates at 550 kPa (80 lbf/in
2
) and is fitted into the crankcase, inside the
timing case.
1 Remove the timing case cover, see Operation 6-1.
2 Push the pressure relief valve open and insert a piece of copper wire into the valve. Use the copper wire to
pull the valve from the crankcase (A).
To fit
1 Clean the joint faces of the timing case cover.
2 Fit the pressure relief valve into position in the crankcase.
3 Fit the timing case cover, see Operation 6-2.
To inspect Operation 10-18
1 Remove the pressure relief valve, see Operation 10-17.
2 Visually inspect the valve assembly for damage.
Caution: If the pressure relief valve is damaged, then it must be renewed.
3 Fit a new pressure relief valve into position in the crankcase, see Operation 10-17.
W141
A
This document has been printed from SPI². Not for Resale