Perkins 1206A-E70TTA, Руководство по эксплуатации и обслуживанию, Страница: 90 / 108

8. Rotate the filter element (5) counterclockwise and
remove the filter element . Clean the filter bowl.
Install the New Filter Element
Illustration 54 g03086798
Typical example
1. Locate the thread in the new filter element (8) onto
the threads (9). Spin on the filter element and
tighten the drain valve (2) securely.
2. Lubricate the O ring seal (7) with clean engine oil.
Do NOT fill the bowl with fuel before the assembly
is installed.
3. Do not use a tool to install the filter assembly.
Tighten the filter bowl (6) by hand. Install the filter
bowl (6). Turn the filter bowl clockwise until the
filter bowl locks into position against the stops.
4. Remove the container and dispose of the fuel in a
safe place.
5. Both primary fuel filters must be replaced. Also, the
secondary filter element must be replaced at the
same time as the primary fuel filters . Refer to the
Operation and Maintenance Manual, “Fuel System
Filter - Replace”.
i07310613
Fuel System Primary Filter/
Water Separator - Drain
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Ensure that the engine is stopped before any servic-
ing or repair is performed.
NOTICE
The water separator can be under suction during nor-
mal engine operation. Ensure that the drain valve is
tightened securely to help prevent air from entering
the fuel system.
The engine is equipped with two primary fuel filters,
one on engine, and another off engine. Both primary
fuel filters require the water draining daily.
90 M0090743
Maintenance Section
Fuel System Primary Filter/Water Separator - Drain