The default setting for an overspeed is 3000 rpm.
The ECM will cut the power to the electronic unit
injectors, until the rpm drops below 200 rpm of the
overspeed setting. A diagnostic fault code will be
logged into the ECM memory and a warning lamp will
indicate a diagnostic fault code.
An overspeed can be set from 2600 rpm to 3000 rpm.
This setting depends on the application.
i05769077
Sensors
and
Electrical
Components
The
illustration
within
the
section
shows
the
typical
locations
of
the
sensors
and
other
electrical
components
on
the
Industrial
engine.
Specific
engines
may
appear
different
due
to
the
application.
Also
illustration
of
the
aftertreatment
system
may
appear
different
due
to
the
application.
SEBU9063-07
53