Perkins 1106C-E70TA, Руководство по устранению неисправностей, Страница: 30 / 31

Number of Switch Inputs
This number is the total number of switches that will
be used. The switches can be individual switches or a
multiple rotary switch.
Table 7
Range Default
0 to 2 0
Mode Selection Number
This parameter is a non-programmable parameter
that represents the number of possible combinations
of switch positions. This parameter is based on the
value that is programmed into the
“ Number of Switch
Inputs ” parameter.
Mode Selection Switch Input 2 and
Mode Selection Switch Input 1
The number of these non-programmable parameters
that are visible depends on the value that is
programmed into the
“ Number of Switch Inputs ”
parameter. “ Open ” signifies that the switch is in the
OFF position. “ Ground ” signifies that the switch is in
the ON position.
Enabled
If “ Yes ” is selected, the ECM is programmed to use
the values in “ Rating Number ” , “ Throttle 1 Droop
Percentage ” , “ Throttle 2 Droop Percentage ” and
“ TSC1 Droop Percentage ” for the given combination
of switch positions.
Table 8
Values Default Factory Password
Yes
No
No Yes
Rating Number
This parameter is the engine rating that is used by the
Electronic Control Module (ECM) for a given
combination of switch positions. There is a maximum
of four ratings in a flash file.
Table 9
Range Default Factory
Password
1 to the maximum
number of ratings in
the currently installed
Flash File
1 No
Rated Speed (RPM)
This parameter represents the engine speed that is
selected when the mode switch or the mode switches
are in a particular position.
Table 10
Range Default Factory
Password
“ Programmed Low
Idle ” to “ Pro-
grammed High Idle ”
5.0% No
Throttle 1 Droop Percentage
This parameter represents the amount of droop that
is applied to the
“ Throttle 1 ” input.
Table 11
Range Default Factory
Password
0 to 10 percent 5.0% No
Throttle 2 Droop Percentage
This parameter represents the amount of droop that
is applied to the
“ Throttle 2 ” input.
Table 12
Range Default Factory
Password
0 to 10 percent 5.0% No
TSC1 Droop Percentage
This parameter represents the amount of droop that
is applied to the
“ Torque Speed Control 1(TSC1) ”
input.
Table 13
Range Default Factory
Password
0 to 10 percent 5.0% No
i05228752
Throttle Setup
The engine can have a digital throttle that uses a
Pulse Width Modulated (PWM) signal, an analog
throttle, or a multi-position switched throttle. The
Electronic Control Module (ECM) must be
programmed for the type of throttle input that is being
used.
Table 14
Throttle 1 Throttle 2
PWM (Digital Throttle) Analog Throttle
PWM (Digital Throttle) None
PWM (Digital Throttle) Multi-position Throttle Switch
(continued)
30 UENR0678
Programming Parameters