Control Panel
1. Run signal light
2. Time signal light
3. Display Screen
4. Frequency signal light
5. Control Knob
6. Start/Stop button
1.
2.
3.
4.
5.
6.
RUN
START
STOP
TIME
FREQ
• RUN
Signal light (green) - lit when the Bead Ruptor
TM
96 Homogenizer is running.
• TIME
Signal light (yellow) - lit when the Bead Ruptor
TM
96 Homogenizer timer
selection is active.
• FREQUENCY
Signal light (yellow) - lit when the Bead Ruptor
TM
96 Homogenizer
frequency selection is active. Frequency is defined as number of wave cycles per
second (1/s). Measured in Hz.
• CONTROL KNOB
(rotate / push) - rotate right (+) Or left (-) to change the Time
or Frequency setting values. Push the Control Knob to switch between Time and
Frequency settings.
• START/STOP
button - press to start or stop the cycle.
WARNING:
Only start the Bead Ruptor
TM
96 Homogenizer with the lid in the closed
position. The display will read “LID” if the lid is open when attempting to start.
Always start and stop the Bead Ruptor
TM
96 with the Start/Stop button.
