Perkin-Elmer XRpad2 4336, Руководство пользователя, Страница: 34 / 67

XRpad2 4336
18 68153 01
D
IGIT
A
L
I
MAGING
8.5.1.7 Disposing of the XRpad2 LBP
To dispose of the XRpad2 LBP:
•
The XRpad2 LBP shall not be disposed with other waste at the end of its
working life.
•
Recycle or dispose the battery in accordance with local, state, and federal/national laws and
environmental regulations.
•
Do not place the battery in fire or incinerate.
•
For transporting, follow the requirements in “Section 8.5.1.4, Transportation and Storage” on
page 16 .
8.5.2 XRpad IPU-2
The XRpad IPU-2 is an Interface and Power Unit. The XRpad IPU-2 combines the Power Supply
Unit with additional communication and trigger interfaces. The tethered power and communica-
tion cable is connected to the X-ray detector. The communication data are split inside the XRpad
IPU-2 into Gigabit Ethernet Interface, Detector Trigger Interface, Hand Switch and Generator
Interface, and Detector Push Button Interface. The Gigabit Ethernet Interface of the XRpad IPU-2
is connected to the Imaging Workstation using a Cat 5e/6 cable. The maximum cable length is
31m. The AC cable must be connected to a properly grounded receptacle. The AC cable is remov-
able and will be plugged to an IEC connector. The XRpad IPU-2 must be connected with a
ground by the functional ground connector ( Figure 6 [13]) or with the potential of the hospital by
the potential equalization connector ( Figure 6 [12]). The socket outlet shall be near the XRpad
IPU-2 and shall be easily accessible. To isolate the equipment electrically from supply main on all
poles simultaneously, the supply main switch ( Figure 6 [1]) must be used.
Figure 6 XRpad IPU-2
WARNING
Connecting the XRpad IPU-2 LAN port directly to the clinical
computer network may disturb the IT environment.
Front Panel Rear Panel
1
2 3 4
5 6 7
8
9 10
11
12
13 14 15 16 17 18