Peripheral Electronics Audio2car PXDX-KD, Инструкция по эксплуатации

Страница: 12 / 20

TOP VIEW
1 2 3 4 5 6 7 8
DIP ON
DIN CONNECTOR / DIP SWITCH VIEW
22-PIN HARNESS VIEW
1.6 Programming the Audio2car
Now that you have identified the correct harness and dip-switch configuration us -
ing the application guide, it is now time to program the interface.
To program the interface, set the dip-switches located on the side of the interface
(see Fig.1 below) to the congfiguration listed for your vehicle in the Application
guide. Switches are in their default setting of “off” in the up position and are turned
“on” when switched down. Refer to the chart on the bottom of this page.
This programs the Audio2car to the vehicle it is being installed in. The dip-switches
MUST be set before the interface is plugged into the vehicle. Otherwise the
Audio2car will not work correctly.
Dip Switch Configuration Chart
Fig.1 Side view of Interface with dip switches
1 2 3 4 5 6 7 8
Config. #1 ON off off ON off off off off
Config. #2 ON off off off off off off off
Config. #3 off off off ON off off off off
Config. #4 off ON off off off off off off
Config. #5 ON ON off off off off off off
Config. #6 off off ON off off off off off
Config. #7 ON off ON off off off off off
Config. #8 off ON ON off off off off off
Config. #9 ON ON off ON off off off off
10