Step 9
- Lye the four posts on the ground with the bottoms at the edge of each hole, with the
tops facing away from each other. Like This:
Step 10
- Lay one beam down on the ground near the top of the posts. Slide the posts up and
onto the beam between the lines on the beam where it says post.
Step 11
-Set the other beam on top sandwiching the post in between the two beams.
Step 12
- Place 1 washer on each
½”
bolt. Lift up the beam assembly enough to fit the bolts
between the ground and the beam and insert the bolts into the holes from the bottom.
Hint:
You may want to use a block of wood to place on the ground under the bolt so you can push
the beam down to get the bolt to come up through the hole. Place a washer and nut on each
of the bolts and make them snug but do not tighten them down yet. Now you should have this:
