Performer High Racer, Инструкция по сборке

Страница: 9 / 16

- 5-
Install Brake and shifter cable
Install handlebar
1. Place the Riser on the stem and tighten riser clamp (pic 14)
2. Align the riser to the front wheel
3. If the stem is not align to the front wheel, please adjust stem by screwing bolts in or
out
4. After alignment, tighten stem
5. Placing handlebar (pic 15)
Adjust handlebar
By adjusting stem
To adjust the angle of handlebar, push the raiser forward and turn the backstop screw in
or out. The backstop screw is close to the stem axle. Turing bolt in and out to let
handlebar fold further back or up
. Don’t turn the screw out so far which will touch the top
of stem when folded back.
By spacer
If the handlebar is too high to hold after you screw in so far. Please take apart the stem
first then take out spacers from fork. There are 2~4 spacers with 1cm in width. The more
spacer you take off the lower handlebar is. Most riders only need to take 2 spacers off
and adjust the backstop screw. Please note that the handlebar should not touch your
knees while riding. Afterward, install the stem and extra spacer you took off then tighten
it.
Pic 14 Pic 15