Performax 241-0976, Руководство пользователя

Страница: 11 / 19

11
LED WORKLIGHT
The LED worklight (1) is turned ON and OFF by
pressing the worklight switch button (2) (Fig. 1).
To turn the worklight ON, press the worklight
switch button once. To turn the worklight OFF,
press the switch button a second time.
FORWARD/REVERSE SWITCH
The forward/reverse switch (1) is conveniently
mounted at the rear of the drill housing (2)
(Fig. 2). To make the drill rotate clockwise for
drilling, slide the forward/reverse switch to the
left. To make the drill rotate counter-clockwise,
slide the forward/reverse switch to the right.
NOTES:
a) Never change the position of the
forward/reverse switch while the chuck is
turning.
b) The switch will NOT function with the
forward/reverse switch in the middle position.
VARIABLE-SPEED SWITCH
This drill is equipped with a variable-speed
ON/OFF switch.
1.
To start the drill, gently squeeze the switch
(1) (Fig. 3).
NOTE: The drill will turn at its slowest speed
when the switch is depressed slightly. The drill
will turn at its fastest speed when the switch is
fully depressed.
2.
To stop the drill, release the switch.
NOTE: Drilling at a slow speed for an
extended period of time may cause the drill
motor to overheat. If the drill gets hot, stop
drilling and allow it to cool for at least 15
minutes.
INSTALLING DRILL BITS
WARNING:
Never hold the chuck body
with one hand and use the drill power to
rotate the drill body to loosen or tighten bits.
Serious injury may result.
1.
Remove the drill plug from the power
source.
2. Rotate the chuck collar (1) to open or close
the jaws (2) to a point where the opening is
slightly larger than the bit size you intend to
use (Fig. 4). Raise the front of your drill
chuck slightly to prevent the bit from falling
out of the chuck jaws.
ASSEMBLY AND OPERATING
!
Fig. 1
Fig. 2
Fig. 3