Performax 241-0500, Руководство пользователя

Страница: 22 / 31

22
FLUSH CUTTING A DOOR JAMB AND
CASING FOR INSTALLING FLOORING
The oscillating tool can be used to flush
cut a door jamb and casing to allow space
for the new flooring to fit neatly under the
door jamb and casing. For the purpose of
demonstrating the procedure, floor tile is
being used.
1. Install the plunge cutting wood saw
blade for wood in the tool
(Fig. 7 Page 17).
NOTE: The blade should be centred on
the tool housing and NOT installed in the
90° position.
2. Place a scrap piece of floor tile (1) on
the floor about 1/2" (25 mm) from the
door jamb (2) (Fig. 13).
NOTE:
Make sure the “good” side of the
tile is facing upward to provide a smooth
surface for the blade to follow.
3. Place the tool with the saw blade (3)
lightly touching the surface of the tile
and the cutting teeth NOT touching
the surface to be cut.
4. Turn the tool ON and set the speed to
the fastest speed (Fig. 12 Page 20).
5. When the tool reaches its maximum
speed, carefully plunge the blade into
the door jamb while sliding the blade
along the floor tile.
NOTE: Hold the tool tightly and do not put
too much forward pressure on the saw
blade when cutting, as this will cause the
tool to vibrate excessively.
ASSEMBLY AND OPERATING
Fig. 13