Performax 240-4823, Руководство оператора, Страница: 10 / 14

- 10 -
IMPORTANT!
Clean or change the cartridge filter regularly for best performance.
ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING . If the machine is used with out the cartridge filter, the
motor will burn out and the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filter included is made of high quality materials designed to stop small dust particles. The
cartridge filter is capable for both wet and dry use A DRY CARTRIDGE FILTER IS NECESSARY TO PICK
UP DUST. If the cartridge filter is wet, it will clog quickly and be difficult to clean. Handle the filter carefully
when removing it for cleaning and replacing it. Check the filters for tears or small holes, a small hole can let
dust pass through and out of the cleaner. Do not use a filter with holes or tears in it, replace it immediately.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE CONTAINER.
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position.
3. Install the cartridge filter over the filter cage with the flat end of the filter towards the vacuum power head.
Carefully push filter in until it stops against the power head. (fig. 2 & 3)
4. Place filter retainer on top of cartridge filter over the raise lip and tighten down by turning retainer
Clockwise, do not over tighten. (fig. 4 & 5)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal. (fig. 6)
3. Clean the cartridge filter by gently tapping or brushing dirt off or washing it with water. Cleaning should
not be done indoors in living areas. For optimal performance a new filter is recommended.
4. Install cleaned or new filter into place as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter cage.
$ !" $ !(' !$ !( % %$ ( $ %