23
‘05 - ‘06 Tacoma (W/ O.E. Hitch) - 3” Kit 5613
e.
Install driver and passenger door sill plates.
4.
Manual transmission
a.
Remove plastic cap from end of shift lever.
b.
Mark alignment and cut lines on shifter lever
below bend.
c.
Cut shifter lever along marked cut line.
Door Sill
Plate
Shift Lever
Plastic Cap
Shift Lever
Cut Line
Alignment
Line
d.
Position kit
extension
(manual shifter) between
two cut pieces of shifter lever. Ensure alignment
marks on each cut shifter lever piece are aligned
and rubber boot is on shift lever.
e.
Weld kit
extension
(manual shifter) in place.
f.
Grind off any excess welds.
g.
Install plastic cap to end of shift lever.
h.
Install shifter lever.
i.
Install shift and center consoles.
WARNING
Welding should be performed by a certified welder.
Kit
Extension
(Manual
Shifter)
Shift Lever
Alignment
Mark
Plastic Cap
Shift Lever
Shifter
Console
Center
Console
