PARTS LIST
TOOLS REQUIRED
ASSEMBLY AND WALL MOUNTING INSTRUCTIONS
• #2 Phillips head screwdriver
• 7 mm wrench
1.
Lay out components and place the side supports (2) with the holes flat on
the ground. Insert screws (4) from the back and hand tighten the nut (5)
from the front. The magnetic strip (1) will use two screws, and each bin
support bracket (3) will use four screws. Assembly is the same if
positioning magnetic strip on bottom, however unit will need to be
rotated 180 degrees and mounted accordingly.
2.
Determine orientation (magnetic strip above or below bins) and location
for bracket and ensure adequate wall space (at least 12 in. on all sides)
is available.
3.
Use a stud finder to locate the studs and position rack against wall with
the mounting holes over the center of the studs. If mounting to studs is
not an option, use the included wall anchors.
4.
Ensure the unit is aligned properly with a level and mark the wall with a
pencil in desired location.
5.
Fasten rack to wall. If using wall anchors drill a 3/16 in. hole at each
mark and insert wall anchors flush with wall. Align rack to wall anchors
and fasten with screws.
NOTE: Make sure there is adequate wall space below mounting rack.
For maximum strength lower bins must rest against wall surface
No. Description
Qty.
1
Magnetic Tool Holder
1
2
Vertical Side Supports 2
3
Bin Support Brackets
2
4
Screws
10
5
Nuts (7 mm)
10
SPECIFICATIONS
Red Bins: ..............................................................4 (6-1/2 L x 4-1/16 W x 3 in. H)
Blue Bins: ..................................................................... 3 (9-1/4 L x 6 W x 5 in. H)
Rack Height: ...........................................................................................16-1/4 in.
Rack Width: .................................................................................................. 18 in.
Rack Depth: ..............................................................................................9-1/2 in.
Construction: .......................................................................Powder Coated Steel
IMPORTANT SAFETY INFORMATION
WARNING! Read, understand and follow all instructions and warnings
before assembling or mounting this tool. Failure to do so may result in
personal injury and/or property damage and will void warranty.
• Do not exceed rated weight capacity.
• Red bin capacity is 5 lbs. each. Blue bin capacity is 8 lbs. each.
• Always inspect bins for any cracks before use. If any damage is found do
not use.
Warnings:
• Total combined total weight capacity of bins is 44 lbs. Do not overload.
• Always inspect bins for any cracks. If any damage is found do not use.
• It is highly recommended you mount unit directly to wall studs.
• Make sure there are no wires, pipes, or other fixtures inside the walls
where you intend to mount the rack.
• Magnet is very strong. Keep away from sensitive electronics or
magnetized objects such as credit cards.
Precautions:
• Note: Double check that there is adequate wall space below and above
rack. For maximum strength lower bins must rest against wall surface.
• The rack mounting holes are approximately 16 in. apart for mounting to
standard wall studs. Use a stud finder to locate studs.
• If mounting to wall studs is not an option use the included wall anchors.
NOTE: Specifications are subject to change without notice.
3
2
4
1
5
