NOT be modified and/or used for any application other than for which it was designed. If you have any questions relative to its
application DO NOT use the tool until you have written Wilmar Corporation and we have advised you.
Technical Service Manager
Wilmar Corporation
350 Midland Drive
Tukwila, WA 98188
EXTENSION CORD SELECTION
Replace damaged extension cords immediately. Use of damaged extension cords can shock, burn or electrocute.
If an extension cord is used, make sure the conductor size is large enough to prevent excessive voltage drop which will cause loss of power and
possible motor damage. A table of recommended extension cord sizes will be found in this section. This table is based on limiting line voltage drop to
5 volts for 115 volts at 150% of rated amperes. If an extension cord is to be used outdoors it must be marked with the suffix W-A or W following the
cord type designation. For example – SJTW-A to indicate it is acceptable for outdoor use.
RECOMMENDED EXTENSION CORD SIZES FOR USE WITH PORTABLE ELECTRIC TOOLS
Length of Cord in Feet
115V
25 Ft.
50 Ft.
100 Ft. 150 Ft. 200 Ft. 250 Ft. 300 Ft. 400 Ft. 500 Ft.
0-2A 18 18 18 16 16 14 14 12 12
2-3A 18 18 16 14 14 12 12 10 10
3-4A 18 18 16 14 12 12 10 10 8
4-5A 18 18 14 12 12 10 10 8 8
5-6A 18 16 14 12 10 10 8 8 6
6-8A 18 16 12 10 10 8 6 6 6
8-10A
18
14
12
10 8 8 6 6 4
10-12A
16
14
10 8 8 6 6 4 4
12-14A
16
12
10 8 6 6 6 4 2
14-16A
16
12
10 8 6 6 4 4 2
16-18A
14
12 8 8 6 4 4 2 2
18-20A
14
12 8 6 6 4 4 2 2
6" CAR POLISHER FEATURES
5
OPERATION
1. Motor housing
2. ON/OFF Switch
3. Oval Palm Grip Handle
4. Foam backing pad
5. Terrycloth bonnet
6. Synthetic wool bonnet
ASSEMBLY
The Performance Tool orbital buffer is packaged and shipped fully assembled.
Be sure to follow the below instructions before each use.
Switching on and off:
1. When starting this buffer, always maintain a firm grip on the tool with both hands to resist starting torque.
2. Using your finger, push the ON/OFF switch (2) while gripping the polisher firmly with both hands.
Allow the pad to rotate to its full speed.
3. To turn off, use your finger to push the ON/OFF switch (2).
APPLICATIONS
The Performance Tool Random Orbital Buffer can be used to polish and buff most high-gloss surfaces. The terrycloth application bonnet
and synthetic wool bonnet are manufactured to apply and remove polishes and waxes. Common applications include: cars, boats, aircraft,
hardwood floors, furniture and more.
PREPARING THE SURFACE
Before you begin, make sure that the surface is clean and dry. The work area must also be dry. Most high-gloss surfaces can be cleaned with
a mild soap and water solution. If necessary, remove stubborn dirt such as road tar, grease and bug stains with a cleaning product designed
for this purpose.
Foam Backing Pad
Oval Palm Grip
ON/OFF
Switch
Motor Housing
