3
IMPORTANT SAFETY INFORMATION
OPERATION
MAINTENANCE & INSPECTION
WARNING
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO SO MAY
RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.
Warning:
Failure to heed these warnings may result in loss of load, damage to jack stands,
and/or jack stand failure resulting in personal injury or property damage.
Warning:
Do not overload jack stands beyond rated capacity. Overloading can cause damage
to or failure of the jack stands.
Warning:
POSITION LOAD ON CENTER OF SADDLE ONLY. ALWAYS USE STANDS IN PAIRS
ON HARD, LEVEL SURFACE CAPABLE OF SUSTAINING THE LOAD. USE OF STANDS
ON OTHER THAN HARD LEVEL SURFACES CAN RESULT IN STAND INSTABILITY AND
POSSIBLE LOSS OF LOAD.
Be sure all personnel are clear of load before lowering load.
Ensure that no personel pass underneath load until load is securely supported
by jack stands.
1. Refer to your vehicle owner's manual for proper jacking procedures. Lift only
on areas of the vehicle as specified by vehicle manufacturer.-
2. Position stands under vehicle at points specified by vehicle manufacturer as
proper load support points.
3. To adjust stands: Hold control
lever up while lifting saddle
shaft to desired height. Push
control lever down to lock pawl
into teeth located in center
column. MAKE SURE PAWL IS
FULLY ENGAGED INTO TEETH.
4. Carefully lower load onto stands.
Saddle
Pawl
Center
Column
Control
Lever
1. Visual inspection shall be made before each use of the stands, checking for
cracks, cracked welds and missing and/or damaged parts. Any stand that
appears to be damaged in any way shall be removed from service immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH THE MISUSE OF
EQUIPMENT OF THIS TYPE, NO MODIFICATIONS SHALL BE MADE TO THE
PRODUCT.
