IMPORTANT SAFETY INSTRUCTIONS CONTINUED
9. Do not operate the portable luminaire with a missing or damaged guard, lamp containment barrier, or UV filter.
10. Avoid electric shock. Do not use with an extension cord near water or where water may accumulate.
Keep lamp at least 16 feet (5m) from pools and spas. Keep plugs and receptacles dry. Use only on GFCI-
protected circuits. Do not submerge the Light in water.
11. The Light is not waterproof. Use extreme caution in any wet location.
12. Be careful when using tripod. Make certain that the area is clear of debris and obstructions that may
bump the Light.
13. Do not obstruct walkways or common areas with the cord.
14. Maintain labels and nameplates on the Light. These carry important safety information.
15. This product is not intended for use in a residence or to be mounted in a cabinet. This product is not
suitable for recessed installation in ceilings or on buildings. This product can cause a fire.
16. Do not leave the Light unattended when it is plugged into an electrical outlet. Turn off the Light, and
unplug it from its electrical outlet before leaving.
17. This product is not a toy. Keep it out of reach of children.
18. People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close
proximity to heart pacemaker could cause pacemaker interference or pacemaker failure. In addition, people
with pacemakers should:
· Avoid operating alone. · Properly maintain and inspect to avoid electrical shock.
· Properly ground power cord. Ground Fault Circuit Interrupter (GFCI) should also be implemented –
it prevents sustained electrical shock
19. WARNING: Handling the cord on this product will expose you to lead, a chemical known to the State
of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.
20. The warnings, precautions, and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
21. Do not operate a Light in explosive atmospheres, such as in the presence of flammable liquids, gases,
or dust. A Light creates sparks which may ignite the dust or fumes.
22. Do not abuse the cord. Never use the cord for carrying, pulling, or unplugging the Light. Keep the
cord away from heat, oil, sharp edges, and moving parts. Damaged or entangled cords increase the risk of
electric shock.
23. Stay alert, watch what you are doing, and use common sense when operating a Light. Do not use a
Light while you are tired or under the influence of drugs, alcohol, or medication. A moment of inattention
while operating a Light may result in serious personal injury.
24. Do not use the Light if the On/Off Button does not turn it on and off. Any Light that cannot be controlled
with the Button is dangerous and must be repaired.
25. Have your Light serviced by a qualified repair person. Use only identical replacement parts. This will
ensure that the safety of the Light is maintained.
26. Always point the Light away from a wall, whether the unit is in use or not. If the Light is accidentally
pointed at a wall while it is on or while it is still hot when turned off, a fire may result.
27. Wear ANSI-approved goggles during setup and use.
Setup
1. Slide the Bracket (13) over the Lower Grip (14), lining the hole in the Bracket up with the bolt hole in the
Grip.
2. Insert the Knob (20) through the Concave Washer (34) and into the hole.
3. Remove the Bolt (38) at the top of the housing and open the Lamp Cover (24).
4. Insert the Bulb (27) into the Bulb Socket (18).
CAUTION: Do not touch the Bulb with your bare hands; oil from skin will drastically shorten the life span
of the bulb if not cleaned with rubbing alcohol and allowed to dry before use. Handle the bulb with a soft,
clean cloth or clean work gloves instead.
5. Close the Lamp Cover (24) and secure with the Bolt (38).
6. Gently squeeze the Wire Cover (25) while placing its four tabs into the Lamp Cover (24).
Secure the tab on the Wire Cover to the Lamp Cover.
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this manual,
including all text under subheadings therein before setup or use of this product.
1. Plug the Light into a standard 120V grounded, electric outlet.
2. Push the On/Off switch on the back of the light.
3. WARNING! Keep the Light away from combustible objects. The light and housing will get
hot enough to start a fire.
4. To turn off, push the On/Off switch.
5. To prevent accidents; turn off lights and disconnect power supply after use.
Allow the Lights to cool. Clean, then store the Light indoors out of children’s reach.
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the On/Off Button is in the OFF position and unplug the tool from its electrical outlet before
performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM LIGHT FAILURE:
Do not use damaged equipment. If damage is noted, have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general condition of the light.
Check for: • loose hardware, • damaged cord/electrical wiring, • cracked or broken parts, and • any other
condition that may affect its safe operation.
2. AFTER USE, allow Light to cool and then wipe external surfaces of the Light with a clean cloth.
Part
Description
Qty
1
Power Cord
1
2
Screw M4*16
4
3
Junction Box Cover
1
4
Junction Box Cover Pad
1
5
Junction Box Base
1
6
Junction Box Hex Sleeve
1
7
Sleeve
2
8
Bolt M4*6
1
9
Fasten Bracket
1
10
Bolt M6*14
2
11
Washer
2
12
Hex Nut
4
13
Bracket
1
14
Lower Grip
1
15
Upper Grip
1
16
Shell
1
17
Soft Sleeve
1
18
Bulb Socket
1
19
Bolt M4*6
3
Part
Description
Qty
20
Knob M6*16
1
21
Reflector
1
22
Glass
1
23
Seal Ring
1
24
Lamp Cover
1
25
Wire Cover
1
26
Plastic Long Plug
1
27
Bulb
1
28
Switch Cover
1
29
Switch
1
30
Wire Nut
1
31
Wire Press Board
1
32
Screw M4*12
2
33
Plastic Short Plug
3
34
Concave Washer
1
35
Large Washer
1
36
Gear Washer
1
37
Spring Washer
1
38
Bolt
1
Part Diagram
