PRODUCT FEATURES
OPERATION
Recharging the Battery Unit
• Select either the 12V car adaptor, 120V AC adaptor
• Plug selected charger into the recharge port
• Connect the charger to the appropriate power source
CAUTION: To prevent damage or injury, and ensure proper performance
be sure to note the following:
• Be sure your vehicle does not require more cranking AMPs than the battery
unit can provide
• Ideally the battery unit should be full, but always confirm it unit has at least
3 solid lights, or 60% charge
• Before starting the vehicle, ensure a good solid connection between the
cables and the battery unit
• Allow a minimum of 10 seconds between attempts to start
• If car does not start after first try, double check the connections and be sure
car battery terminals are clean
• If car still will not start after several attempts, disconnect and investigate
other potential problems
• Store battery unit at temperatures between 40º and 120ºF. To avoid
damaging the internal cells, do not expose to excessive heat
1. LED Light
2. 12V Jump Starter Port
3. 12V 3.5A Laptop Charging Port
4. Battery Level Indicator
5. On/Off Switch
6. 5V 2A USB Port
7. 12V 2A Charging Port
8. 5V Input Recharge Port
Battery Level Indicator
• Press on/off button once to check battery level
• Unlit – 0%
• 1 flashing – 10%
• 1 solid – 20%
• 2 solid – 40%
• 3 solid – 60%
• 4 solid – 80%
• 5 solid – 100%
• Lights will flash during charging and will all be lit when charging is finished.
Using The Smart Clamp
1. Connect the smarts clamps to the jump starter power bank battery. Check
the indicator LEDs on the smart clamp for the following:
a. If the red indicator LED on the smart clamp lights up, there may be
insufficient change in the jump starter. Recharge power bank and try again.
b. If smart clamps alarm, disconnect the clamps and check connections for
correct polarity. An audible alarm means there is a short circuit or reverse
polarity.
c. In case of any of the above, disconnect the clamps and reconnect properly.
d. If red and green indictor LEDs stay on the vehicle may require more current
that the jump starter can provide. Compare the required amperage of your
vehicle with the jump starter. A larger capacity jump starter may be required.
2. Alternating red and green indicator LEDs on the smart clamp indicate there
is sufficient charge.
3. Once attached, the green indicator on the clamps should stay on, indicating
sufficient charge and proper connection. Your vehicle is ready to jump.
4. After proper connection, smart clamp will shut off automatically after 30
seconds. Reconnect if vehicle still needs to be jump started.
5. Red indicator LED will blink and clamps will alarm after a successful jump.
Jump Starting a Car
WARNING: to prevent damage to the battery unit disconnect the charger
from the battery immediately after the vehicle has been successfully started.
• Be sure battery unit is at least 60% full
• Connect the red clamp to the dead batteries positive (+) terminal
• Connect the black clamp to the dead batteries negative (-) terminal
• Plug the other end of the cables into the jump starter port on the
battery unit
• Start the vehicle
• Once started unplug cables from battery unit, then remove the red
clamp, followed by the black clamp
Charging Cell Phones, Tablets and other Portable Electronics
• Plug the multi-adaptor USB cable into the 5V USB 2A port
• Select the appropriate adaptor for your cell phone, tablet or other
portable device
NOTE: if your device is not compatible with the included adaptors, you can plug
the USB charging cord from your device directly into the battery unit
• Press the on/off button to charge
1
2
