3
1. If desired, for quick tool connection, you will need to prepare a 1/4 in. quick air connector
(not included) to connect to the air source hose. First, wrap the 1/4 in. quick air connec-
tor (not included) with pipe thread seal tape (not included) before threading it onto the
3/8 in. air source hose. Then, connect the 1/4 in. quick air connector to the Air Inlet (2)
on the Air Caulking Gun. Note: If you are not using an automatic oiler system, before
operation, add a few drops of Pneumatic Tool Oil to the airline connection. Add a few
drops more after each hour of continual use.
2. To check your air system, set the air pressure on your compressor to 90 PSI. Do not
exceed the testing air pressure of 90 PSI.
3. Check the air connection for leaks. After test is complete, disconnect from the air supply
until caulk is loaded into the Air Caulking Gun.
13. Maintenance. For your safety, maintenance should be performed regularly by a quali-
fied technician using original PERFORMANCE TOOLS® replacement parts. Failure
to do so can lead to accidents for the operator. Use of any other parts will void the
warranty. Only use accessories intended for use with this tool. Approved accessories
are available from Performance Tool®. Use only accessories that are recommended
by the manufacturer for your model. Accessories that may be suitable for one tool may
become hazardous when used on another tool.
WARNING:
This product and its packaging contain a chemical known to the State of
California to cause cancer, birth defects, or other reproductive harm.
WARNING:
The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator. Read and understand all of the instructions
provided in the instruction manual of this product, as well as, any other tool (s) used with
this product.
IMPORTANT SAFETY INFORMATION
OPERATION
NOTE: For best service you should incorporate an oiler, regulator and inline filter.
Oil tool before each use.
4 to 5 drops of a good grade Air Tool Oil placed in the air inlet is
sufficient. Use proper air pressure and CFM rating listed for this tool.
Drain water from hoses and
compressor tank.
Water in the
air supply line will cause
gumming and loss of power.
Clean the air filter on the
supply line and flush the tool
with gum solvent or a 50/50
mix of air tool oil and kerosene.
It may be necessary to
disassemble the tool to
properly clean and re-lubricate.
LUBRICATION & MAINTENANCE
Motor
Oil
Trans.
Fluid
Brake
Fluid
Water
Whip
hose
Air Tool
Oil
Yes
No
