INSUFFICIENT POWER:
Probable Cause
Solution
Dirty or clogged air passages ......... Flush and lubricate tool, drain air tank and supply line
Insufficient air supply ...................... Increase line pressure, Make sure compressor
matches tool's air pressure and consumption needs
Air leakage...................................... Use Teflon tape at all fittings and joints. Check tool for
worn or damaged O-rings & seals.
Worn/damaged wear & tear parts ... Replace as necessary.
Tool matching ................................. Be sure you are using a tool suited for the torque
requirements of the job at hand.
TROUBLESHOOTING
PARTS LIST
1 Housing
1
2 Housing Ornamental 1
3 Housing Ornamental 1
4 Screw
4
5 Trigger
1
6 Trigger Pin
1
7 Air Regulator
1
8 O-Ring
4
9 “E” Retainer Ring
1
10 O-Ring
1
11 Air Inlet
1
12 O-Ring
1
13 Valve Stem
1
14 O-Ring
1
15 Spring
1
16 O-Ring
1
17 Cover
1
18 “E” Retainer Ring
1
19 Bearing
3
20 End Plate
2
21 Rotor
1
22 Rotor Blade
5
23 Cylinder
1
24 O-Ring
1
25 Dowel Pin
1
26 Standard Anvil
1
27 Key
1
28 Rear Gasket
1
29 Plate
1
30 Spring Washer
13
31 Screw
8
32 Pole
4
33 Screw
2
34 Screw
2
35 Acentric Block
1
36 Screw
1
37 Bearing Housing
1
38 Bearing Gasket
1
39 “V” Gasket
1
40 Screw
1
41 Subassemply
2
42 Base
1
43 Settled Screw
12
44 Base
1
45 Screw
1
# Description
Qty.
# Description
Qty.
# Description
Qty.
Ram Assembly Parts List
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil placed in the air inlet is
sufficient. Use proper air pressure and CFM rating listed for this tool.
Drain water from hoses and compressor tank. Water in the air supply line will cause
gumming and loss of power. Clean the air filter on the supply line and flush the tool with
gum solvent or a 50/50 mix of air tool oil and kerosene. It may be necessary to
disassemble the tool to properly clean and re-lubricate.
LUBRICATION & MAINTENANCE
Motor
Oil
Trans.
Fluid
Brake
Fluid
Water
Whip
hose
Air Tool
Oil
Yes
No
