MAN-0012 Rev. I
P a g e
| 28
TOGGLE ATTACHMENT: MICROLINE STEERING LINE
1) Once you have routed the
steering line through the guide
ring on the riser, continue by
routing the steering line through
the grommet in the toggle as
shown. Always start routing from
the hook and loop fastener side.
Create a loop 2 3/16" (5.6 cm)
long. Note: The loop length may
need to be adjusted, depending
on the particular toggle.
2) Now make an overhand knot
with the loop you created. Pull the
knot tight, while keeping the knot
just below the toggle mark.
3) Now slide the loop over the
toggle, starting at the lower end
of the steering toggle. The loop
should be tight around the
toggle when the loop is centered
on the grommet.
PD recommends that the
excess line be finger trapped
as shown.
