Fan
Mode
Energy
Saver
Follow
Me
CHECK FILTER FEATURE:
Press “Check
Filter” button
DO THIS:
FOLLOW ME FEATURE:
(on some models)
Light flashing
Displays
This feature is a reminder to clean the Air Filter for
more efficient operation. The LED (light) will illuminate after
250 hours of operation. To reset after cleaning the filter, press
the “Check Filter” button and the light will go off.
NOTE: CHECK FILTER button
NOTE: FOLLOW ME indicator light
To activate the Follow Me feature, point the remote control
towards the unit and press the “Follow Me” button. The remote
displays the actual temperature at its location. The remote control
will send this signal to the air conditioner every 3 minutes
until the “Follow Me” button is pressed again. If the unit does
not receive the “Follow Me” signal during any 7 minute interval,
the unit will beep to indicate the Follow Me mode has ended.
The actual temperature can be displayed at the unit by
pressing the “Fan” only mode. When in the “Cool” mode, the
unit display indicates the set temperature.
This feature can ONLY be activated from the remote control.
The remote control serves as a remote thermostat allowing for
precise temperature control at its location.
AIR CONDITIONER FEATURES (CONTINUED)
Low
Auto
Med
High
TEMP/TIMER
Auto
Cool
Dry
Fan
Fan
Mode
On
Off
Sleep
Timer
Check
Filter
Energy
Saver
Follow
Me
Low
Auto
Med
High
TEMP/TIMER
Auto
Cool
Dry
Fan
Fan
Mode
On
Off
Sleep
Timer
Check
Filter
High
Fan
Fan
Mode
Energy
Saver
Follow
Me
DISPLAYS:
The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one
to the other, press and hold the Up and Down Temp/Timer buttons at the same time, for 3 seconds.
Error Codes:
AS
-
Room temperature sensor error -
Unplug the unit and
plug it back in. If error repeats, call customer service.
NOTE:
In “Fan” only mode, unit will display “Lo” or “Hi”.
NOTE:
If the unit breaks off unexpectedly
due to power being cut, it will restart with
the previous function setting automatically
when the power resumes.
-
Evaporator temperature sensor error -
Unplug the unit
and plug it back in. If error repeats, call customer service.
(“ ” is displayed as shown in left picture.)
HS
-
Electric heating sensor error
-
Unplug the unit and
plug it back in. If error repeats, call customer service.
NOTE: DISPLAYS
Shows the set temperature in “°C” or “°F” and the Auto-
timer settings. While on “Fan” only mode, it shows the
room temperature.
ADDITIONAL THINGS YOU SHOULD KNOW
The Cool circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. After unit
is turned off, leave unit off for a minimum of 3 minutes before attempting to turn back on. This prevents
overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time.
Air Directional Louvers
HOW TO USE:
The louvers will allow you to direct the air flow
left or right throughout the room as needed.
Move the levers from side to side until the desired
left/right direction is obtained.
Lever
8
